Monday, March 26, 2007

Progress

I know the photo looks like the logo for kids space toy, but to me it's progress.

This weekend I managed to cut all of the 4th Frame. Now I have the transom, Frames 1, 2 and 4. I'm mising frame 3 as I did not have a clean peice of Oak large enough for the cross beam. Frame 3 is next.

(The cross beam on Frame 4 is left long for fitting.)

Once that is complete, I have to get some marine ply for the gussets and for the stem.

And for the Centerboard.

Then there's the keel. That is a 5/4" * 4" * 12' Oak board, and Brookes only sell 9' boards. I think there's a little bit of work with the phone book in my near future.

Wednesday, March 14, 2007

More Planes


I've inherited these from my Grandfather. They look like they've been left on a shelf for quite a while... I guess some clean up is in order...

D

Monday, March 12, 2007

Why the slow down

In the last while,

* I've build a small tool shed (for the boat parts and heavy tools)
* Wired up some new light fittings
* Built a built in wardrobe
* Gone on holidays

So now I'm back building, hopefully there will be more to report..... And a few more pictures.

Saturday, March 10, 2007

Planing Oak

I actually got some work don on the boat today. I took some of my rough Oak boards and planed planed and thicknessed them ready to mark and cut Frame and Frame 4.

It takes a lot of passes to get the cup out of the boards, but at least I can record the exact setting of the thicknessor so that each piece is the same thickness.

When running 7 inch wide oak through the thicknessor (A Woodster pt85) I can turn the handle about 1/8 of a turn each pass, and take off about 1/4 mm. Any more and the machine grinds to a halt. (Previous Posts)

I guess it is a little unfair asking a hobby machine to deal with 7" wide oak boards. But if I go slowly it copes. The finish would drive a cabinet maker to drink, but then I'm making a boat to sail, not to stare at.

I've sort of decided to redo the transom frame. Now that I have a table saw I reckon I can do a better job of the bevels. But that's another day.

I set up the table saw fully last night. The Easiest way of getting the side extension tables level with the main table is to take off the guard, lower the blade right inside the saw, flip it upside down on a large table and attach the side extensions there. They cannot but be level with the saw table. Worked a treat.

The forecast is poor for tomorrow, so I will probably settle for simply marking out the frames and then try to cut them after work during the week.

D

Sunday, March 04, 2007

More Toys - A drill driver


I have lived from some time with a cheap and cheerless 18v portable drill. Pretty good when the battery was charged, but the battery didn't last very long, and I drained a battery just doing the floor of my "boat shed".

Then I came across this Makita cordless impact driver set . It's a world apart from my old toy cordless. The quality is obvious in just handling it. The impact driver easily belts screws into solid oak without any of the usual ruining of the screw heads. And I got it up in the US for less than half the price of buying it in Europe. Add a €20 transformer and off you go.

By the way - why are power tools so much cheaper in the US? Who's making a small fortune on the ones sold here in Ireland?

A boat shed


Not so much for putting the boat in, but rather somewhere to put some of the accumulation of tools and parts for the boat, to free up the kitchen.

I couldn't find anything the size I want so I built one myself.